No complex programming steps are required to set it up for basic operation. Simply use a pen to press the set button on the side of the switch, and then send a signal from a controller to dictate its unit code. Scene capability is provided by using Leviton Wall-Mounted Scene Controllers. This capability will allow multiple enhanced X10 switches to immediately go to different programmed dim levels in response to a single X10 extended code command. This eliminates the time delays associated with sending out one signal after another to individually set multiple X10 switches to different levels.
The Leviton Enhanced Dimmer Switch is ready for three or four-way circuits. A 3-way circuit requires one Leviton Enhanced Dimmer Switch and one slave switch. A 4-way circuit would require a total of two 2 slave switches. Simply add additional slave switches for 5, 6 or more way circuits. For single pole applications, just cap off the yellow traveler wire. Please note that you must use the slave switches below, existing 3 or 4 way mechanical switches or slaves from other X10 switches will damage the dimmer.
Rated for incandescent and transformer-based loads up to 1000 watts. Uses a neutral wire at the switch for transformer-based lighting. Neutral wire is optional when used with incandescent lighting. Intellisense circuitry enhances sensitivity and reliability of X10 signal reception.
Comes with an interchangeable white/ivory paddle switch cover. almond, black, white, ivory or grey paddle & trim replacement kits are available (sold separately). Slaves switches come in white, ivory and almond. Use the black or grey trim kits to change the color of any of the slave switches. Trim plate is not included.
Specifications |
| Manufacturer: | Leviton |
| Manufacturer Product No.: | HCM10-1SW |
| Rating: | For incandescent and transformer-based loads up to 1000W |
| Compatibility: | X10 receiver
3 or 4-way circuits |
- 1000W Leviton Enhanced X10 Dimmer Switch
- Interchangeable white/ivory paddle switch cover
